A Power Conditioner saving Energy for domestic and small commercial establishments, which regulates voltage and improves power factor

SAVELEC is a power conditioning equipment for electrical utility systems beyond the distribution board. It is essentially a Power Quality Equipment suitable for Small Commercial Establishments, , Small Industries, Homes and apartments. The equipment is connected after the meter and is provided with an input MCB for protection.

SAVELEC is a three-in-one concept with the following features:

• Conditioning the voltage wave form by smoothening the crest factor
• Regulation Of voltage
• Improvement of Power Factor

Principle of Operation

SAVELEC Power Saver is a Wave Form Profile Corrector and a dynamic Line Voltage Conditioner, along with a dynamic near unity power factor corrector. SAVELEC is an intelligent unit incorporating a micro-controller to continually optimise and adjust the Power transfer to the load as per its requirements. A low loss variable reactance and a variable capacitor provide the correct matching impedance for the load circuit there by improving the efficiency in the transfer of Power. Thus, optimal input power is achieved by the optimization of Voltage, current, and power factor depending upon the load, resulting in substantial power savings.

SAVELEC saves 18 to 20% power in normal lighting, fan and other small single-phase loads, subject to the system characteristics. SAVELEC Units are available in Single-phase version or in Three-phase version depending upon the type of load.

Technical Features

• An intelligent micro-controller with a built-in software program adjusts the system impedances by switching in appropriate inductance and capacitance into the circuit using high break and make relays to facilitate input current reduction.
• Protection to the input and isolation for the equipment are provided using adequately rated MCBs on the line.
• SAVELEC ensures reduction in the voltage distortion of waveform and provide reactive current support. This reactance in the equipment also provides surge impedance which will reduce the effect of spikes and transients.
• SAVELEC obviates any requirement of voltage stabilizers.
• A changeover switch is provided for the bypass of the equipment in the event of any failure of components of SAVELEC.
• Options of solid-state relays and manual operations are available.